Low-Rider II Pinewood Derby Car Kit

MAXIMUM VELOCITY!^®

Low-Rider II
Pinewood Derby Car Kit

Standard Wheelbase

Extended Wheelbase

The new LOW-RIDER II pinewood derby car has a lower profile than its predecessor, allowing it to slip down the track at top speed. The curved body not only enhances the appearance of the car, but also shifts the center of gravity closer to the rear axle, thus enhancing the performance.

The LOW-RIDER II Kit includes a pre-cut and drilled pine block, tungsten weight, and instructions. Weight pockets are located under the car. Wheels and axles are not included, so use the wheels and axles supplied by your club or order them separately.

Two types of standard wheel base versions, and an extended wheel base version are available:

Standard Wheel Base - Axle Slots: Precision-cut axle slots that match BSA specifications in placement, depth, and width.

Standard Wheel Base - Axle Holes: Precision-drilled axle holes that match BSA specifications for placement. The holes are drilled with a #44 bit (fits BSA axles). One front axle hole is slightly raised so that the car will ride on three wheels (best performance).

Extended Wheel Base: Precision-drilled axle holes located at an extended position. The holes are drilled with a #44 bit (fits BSA axles). One front axle hole is slightly raised so that the car will ride on three wheels (best performance).

The following standard options are available:

Drilled axle holes, 4 wheels on the ground - add $1.00

Drilled axle holes for Awana axles (3/32" bit) - add $1.00

Extended wheel base block with standard slots - add $1.00

Stripes & Flames, Custom Designs, and Flaming Cobra decal sheets were used to customize the cars in the photos.