Low-Rider Kit

MAXIMUM VELOCITY!^®

Low-Rider Kit

Standard Wheelbase

Extended Wheelbase

THE LOW-RIDER has a low profile to slip down the track at top speed. The curved body not only enhances the appearance of the car, but also shifts the center of gravity closer to the rear axle, thus enhancing the performance.

The LOW-RIDER Kit includes a pre-cut and drilled pine block, lead weight, and instructions. Additional weight pockets are located under the car. Wheels and axles are not included, so use the wheels and axles supplied by your club or order them separately.

Two types of standard wheel base versions, and an extended wheel base version are available:

Standard Wheel Base - Axle Slots: Precision-cut axle slots that match BSA specifications in placement, depth, and width.

Standard Wheel Base - Axle Holes: Precision-drilled axle holes that match BSA specifications for placement. The holes are drilled with a #44 bit (fits BSA axles). One front axle hole is slightly raised so that the car will ride on three wheels (best performance).

Extended Wheel Base: Precision-drilled axle holes that match BSA specifications for placement. The holes are drilled with a #44 bit (fits BSA axles). One front axle hole is slightly raised so that the car will ride on three wheels (best performance).

The following standard options are available:

Drilled axle holes, 4 wheels on the ground - add $1.00

Drilled axle holes for Awana axles (3/32" bit) - add $1.00

Extended wheel base block with standard slots - add $1.00

Stripes & Flames and Custom Designs decal sheets were used to customize the cars in the photos.