The VELOCINATOR is our lowest profile car kit. At just 1/4" inch thick, The VELOCINATOR 'slips' down the track at top speed.
The VELOCINATOR is equipped with underbody weight pockets, which allow considerable freedom in weight placement. By adjusting the placement of the 3/16 inch tungsten cubes, the following balance points can be achieved (measured forward from rear axle)
Balance Point
Wheel Type
Minimum
Maximum
Official BSA Speed 3.3gram
7/8 inch
2-1/4 inch
Outlaw/Pro-Ultralite BSA Speed 1.0 gram
15/16 inch
2-1/8 inch
The VELOCINATOR Kit includes a pre-cut pine block with weight pockets, 3/16 tungsten cubes, and instructions. Wheels and axles are not included, so use the wheels and axles supplied by your club or order them separately.
Two types of standard wheel base versions are available:
Standard Wheel Base - Axle Slots: Precision-cut axle slots that match BSA specifications in placement, depth, and width.
Standard Wheel Base - Axle Holes: Precision-drilled axle holes that match BSA specifications for placement. The holes are drilled with a #44 bit (fits BSA axles).
