Predator Pinewood Derby Car Kit

MAXIMUM VELOCITY!^®

Predator
Pinewood Derby Car Kit

Bottom View

The PREDATOR is low, sleek and fast. Varying from 1/4 inch to 5/16 inch thick (at the front axle), the PREDATOR easily slips down the track, producing top results. With the Tungsten Canopy, the bulk of the weight is focused in one area, minimizing the rotational inertia of the car.

The Predator Kit includes a pre-cut and drilled pine block, tungsten canopy and trim weight, and instructions. Weight pockets are located under the car for fine tuning. Wheels and axles are not included, so use the wheels and axles supplied by your club or order them separately.

Two types of standard wheel base versions, and an extended wheel base version are available:

Standard Wheel Base - Axle Slots: Precision-cut axle slots that match BSA specifications in placement, depth, and width.

Standard Wheel Base - Axle Holes: Precision-drilled axle holes that match BSA specifications for placement. The holes are drilled with a #44 bit (fits BSA axles). One front axle hole is slightly raised so that the car will ride on three wheels (best performance).

Extended Wheel Base: Precision-drilled axle holes located at an extended position. The holes are drilled with a #44 bit (fits BSA axles). One front axle hole is slightly raised so that the car will ride on three wheels (best performance).

The following standard options are available:

Drilled axle holes, 4 wheels on the ground - add $1.00.
Drilled axle holes for Awana axles (3/32" bit) - add $1.00.
Extended wheel base block with standard slots - add $1.00.